Tess65 Tri-mode hotswap PCB software and refresh Guide

1.How to recognize in VIA?

2.How to switch wired/2.4G/bluetooth mode?

3.How to refresh pcb?

4.How to restore default setting?

5.The default list of shortcuts

 

1.How to recognize in VIA?

Make sure your keyboard at wired mode or 2.4g mode first, bluetooth mode can not recognize in VIA.

Load this json file in VIA(do not click Use V2 definitions), and then back to configure page can recognize tess65 keyboard.

2.How to switch wired/2.4G/bluetooth mode?

Make sure the switch is left to on when you use 2.4g mode or bluetooth mode.

-Connect bluetooth mode:

long press FN+Q/W/E until the blue light flash quickly,then you can find the bluetooth device TESS65-BT1/TESS65-BT2/TESS65-BT3, the bluetooth light will keep 3seconds if paired successfullly or flash quickly 30seconds then off if not paired successfully.

After paired successfully,each time you want to change bluetooth mode to use, short press FN+Q/W/E then switch to bluetooth mode.

-Connect 2.4g mode:

long press FN+R until the green light flash quickly,then plug in 2.G receiver to your computer(make sure the keyboard close to 2.4g receiver when paird first time), the green light will keep 3 seconds and then off if paired successfullly or flash quickly 30 seconds and then off if not paired successfully.

After paired successfully,each time you want to change 2.4g mode to use, short press FN+R then switch to 2.4g mode.

-Connect wired mode:

Short press FN+T,untill the red light flash 3 seconds,plug USB_C cable to use wired mode.

 

3.How to refresh pcb?

 ①Open QMK,load hex file,click auto flash. QMK download

②Turn off the switch on the pcb(right to off), unplug USB_C cable, press FN+ESC a while and not release, then plug USB_C cable. It will refresh sucessfully.And then unplug and plug USB-C cable, it will work.

4.How to restore default setting?

Long press FN+ESC until red light 3 flash times.

5.The default list of shortcuts

FN+Q=switch to TESS65-BT1 bluetooth mode

FN+W=switch to TESS65-BT2 bluetooth mode

FN+E=switch to TESS65-BT3 bluetooth mode

FN+R=switch to 2.4G mode

FN+T=Switch to wired mode

FN+1-0(number key)= F1-F10

FN+P(3 seconds)=Switch to win/mac layout

FN+L_CTRL= 1-0 key(number key) will be locked to F1-F10, if need 1-0 should press again.

FN+L_WIN(3 seconds)=lock win key

FN+Space=Show remaining battery(green light below 1-5 number keys,5 green -light-100% battery,4 green light-80%,3 green light-60%, 2 green light40%, 1 green light-20%）